PROJECT X 6.0 Steel Iron Shafts 4-PW .355 Tip Std Length-Pulled Bridgestones J40 For Sale


PROJECT X 6.0 Steel Iron Shafts 4-PW .355 Tip Std Length-Pulled Bridgestones J40
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.;

Buy Now

PROJECT X 6.0 Steel Iron Shafts 4-PW .355 Tip Std Length-Pulled Bridgestones J40:
$135.00

Precision Project X flighted rifle shafts 6.0 flex. Made in USA

7 shafts 4-pw standard 1/2” length gaps. I believe the 5 iron measures standard American 38” and not the typical Bridgestone std Japan length of 37.75”. I am never positive without a good club ruler. Either way they are going to vary based on the heads you install them into. They will be somewhere very close to standard.


This listing is for the shafts and grips only. The iron heads are not included. I will be pulling these off as soon as I know I have a buyer. They are totally stock from a set of Bridgestone J40 cb irons. Never been removed since they were built at factory. Still have Bridgestone branded golf pride tour velvet grips (included)


I can try to leave ferrules on but I’d recommend just buying some new ones and installing them. Makes it way easier and better looking. If you use the buy it now I will clean and tip prep these tips for you. I promise they will look fantastic. And I can even send pictures of the tips after I pull and finish the. Before this ship out so you can approve the final result!


No surprises. I can only find very minor wear to the outside edges of the project x labels. And almost no wear at all to the shaft metal only very very minor surface swirls. Which could probably be buffed out for the most part. I can’t even get a picture to show up. I usually walk with a 14 divider golf bag. But I honestly haven’t ever played these much because I don’t do well with this flex.

Grips are installed label side up to match label side of shafts (they were installed with both labels down from factory.

These are taper tip .355” I do have some shims I can throw in if you need them too.

Message with any questions.


PROJECT X 6.0 Steel Iron Shafts 4-PW .355 Tip Std Length-Pulled Bridgestones J40. Condition is \"Used\". Shipped with USPS Priority Mail.


Buy Now

Other Related Items: