Cobra ZL Driver Review
- November 17, 2010, 7:07 pm
- In Drivers
The ZL in the Cobra ZL name stands for Zero Limits. To reach this goal when designing the new ZL driver, the project team pooled the 9 point face technology, with Multi Material construction, Stainless steel Weight screw technology with Adjustable Flight Technology, “AFT”. The objective was the built the BEST driver for the most distance, the best ball flight for every golfer, and overall best performance.
Adjusting the face angle is simple as the driver comes with a wrench to loosen the set screw in the sole of the club at the end of the hosel. The shaft adapter fitted on the shaft is marked with the 3 letters, N, C, and O, for easy alignment with the index mark on the hosel of the head. By the easy adjustment, you can adjust the face angle for 1 degree Open, to .5 degree closed to a full 2 degrees closed.
Along with being able to adjust the face angle, the strategy also allows for quick and easy shaft exchange. The Cobra ZL is not restricted to ONE factory standard shaft, but a large assortment of aftermarket elevated quality custom shafts.
The Cobra ZL comes in 4 choices of loft. 8.5* , 9.5*, 10.5* and 11.5*. The 8.5* driver is only available in Right hand version. A light weight composite crown and sole, and a weight screw to fine tune the CG and ball flight. Each shaft comes with an aluminum shaft adapter for speedy and easygoing custom fitting of the driver to the purchaser.